![]() ![]() Jabo's Direct3D8 Plugin is not recommended. If your PC doesn't support this, you'll have to use the Project64 Video Plugin instead. In the Settings menu, go to the Plugins section and change your Video (Graphics) Plugin to GlideN64. To do this, launch Project64 and navigate to Options ⇒ Configuration or press Ctrl+T to open the Settings menu. Recommended Settings Video (Graphics) Plugin If you use a keyboard, you will also want to increase the Analog Stick ⇒ Range to 100%. It is recommended you push these buttons only far enough that it registers instead of until it clicks. Since these are two distinct controls on the same physical button the input plugin accepts both. L and R are both analog triggers and digital buttons. ![]() The GameCube controller works differently than modern controllers. Whenever you bind one of the triggers, if you press it all the way down until it clicks it will bind two controls in rapid succession. There is a common issue with GameCube controllers that happens if you are using Project64 Input Plugin and using its options that lets you bind all of the controls. You may need to change these again if you switch controllers. Click on the button for the control you want to bind a button to and the menu will wait for you to press a button on the controller or a key on your keyboard to use for the button. 2 The XControl column is the button on your controller, and the N64 column is the button on the N64 controller you want it to use.įor other controllers and keyboard users, use the default Project64 Input Plugin or if N-Rage works better for you ensure that XInput does not have a check by it. This will change the bind menu to be more appropriate for your device. Then navigate to Options ⇒ Configure controller plugin. When using an Xbox controller, or any controller that is an XInput device, you must first go to Options ⇒ Configuration ⇒ Plugins and change the Input (controller) plugin from Project64 Input Plugin to N-Rage for PJ64. Ensure the controller is calibrated, and if you are using one of the controllers with additional setups steps in that guide make sure you follow them. 4.3 Error: uCode crc not found in INI, using currently selected uCodeįirst, read the Controller Setup guide.4.1 Alt+Tabbing Crashes in Full-Screen Mode.3.2 Pause/Unpause Emulation when Window is not Active. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |